Hot End Tips
Sometimes it happen that the flow rate of the plastic into the hot end is not stable, Consequently you can get trouble with your printed parts.
Printed on 28-04-2013
A complete set of ABS plastic parts for the Framebox versionof the Prusa i3 3D printer.
The Set include also the Greg's Geared Extruder V3 Groovemount version.
Prusa Mendel V2
Plastic parts for Prusa Mendel V2 already completed.
ready for shipment just from tomorrow morning
Importance of Filament
Here is a picture of two pieced of filament for 3 mm ABS.
Of course the Yellow one is a good piece and unfortunately the blue one ..is not!!
Is a matter of fact, that when you buy filament from different supplier you have to change some parameter in your slicer software.
But sometimes even with the best setting you get in trouble with your prints and you waste a lot of material and time looking for a solution.
We want to share with all of you our experience about a filament that we bought on the polish market some week ago. Anyway, that filament was not so cheap, so we did not think the supplier was an improvised filament producer.
AS follow we describe what we found and the problems we had.
Prusa i3 Box Frame
Now printing a prusa i3 plastic parts for Box frame
April 24th, 2013
From 25-04-2013 all the Prusa Mendel V2 wiil be Produced with Greg's Geared Extruder V3 included in the set.
April 23rd, 2013
Prusa Mendel V2 ready for Shipment.
Available on Ebay at
April 23rd, 2013
3D LabteK printer .... the prototype is now printing a Prusa mendel V2 ABS plastic parts Set.
April 22nd, 2013
Building the Revision 2 of the 3D Labtek Printer
Estimate completion time one week.
April 21st, 2013